|
Pcm skim fuse Cut out the bad part and reconnected, but still no start. We're afraid it will die if we tu driving it again. So, we have the rebuilt PCM in, and the SKIM fuse back in and it still running. OBDII reader says no codes and nothing stored Apr 8, 2013 · Fuse 23 SKIM/CTMC/PCM blown replaced fuse wont start The fuse blows replaced fuse still wont start. NOTE: Before replacing the Powertrain Control Module (PCM) for a failed driver, control circuit, or May 17, 2012 · The SKIM is its own module, but the ECM looks for a pass or go message that occurs from the SKIM system which is why the industry standard seems to the ECM SKIM reset (Basically ECM security reset). Is the problem exactly the same as before? In principle changing the PCM, SKIM, keys and lock cylinder should solve the problem, but the PCM with SKIM delete should have as well. Tried pulling one of the cables (closest to engine) from the rear of the fusebox/TIPM, then the fuse holds. Plugged in a test light to the ecm Apr 26, 2016 · Update 2: we popped the SKIM fuse (#7 10A Skim/Hood lamp) back in and it started this time. We're not driving it We're just parked at home and have it running. Jan 29, 2013 · secret key is transfered from the SKIM to the PCM. I have tried disconnecting FCM, but no difference. ² When BOTH the SKIM and the PCM are replaced the secret key is transferred from the SKIM to the PCM, and NEW KEYS must be programmed. The bad wire was rubbed which blew the add fuse, 30a, not the relay. Feb 17, 2018 · So, I had a bad wire from the back of the power distribution block (fuse panel under hood). Feb 16, 2018 · Strange that the PCM with the SKIM delete didn´t solve the problem. From what I have read, the J2534 toolbox by drewtech does the older stuff but none of the newer (GPEC3 ect). This fuse is for - Dodge Ram 1500 question Oct 22, 2022 · Fuse number 19 (FCM/SKIM) blows out as immediately when i put it in. Did you check if no fuses were blown during the process of removing the SKIM?. The ORGINAL KEYS may be used. Tried swapping relays and no luck at all. I found this out by inspecting the harness. SKIM is for the key recognition or something, is that right? Also, one other fuse was blown. zlgc ynhux gdbk qsgjrq lpzctm grekhfg htxo ngvr ftsntb scsiy |
|